For more high-output battery assembly machineinformation, please contact us. We will provide professional answers.

Daly BMS wiring diagram of Battery Pack in Parellel

The PACK parallel BMS is a battery management system that consists of two parts: the BMS and the parallel current limiting module. Both parts must be present in each PACK that is connected in parallel.

There are two methods for wiring the PACK parallel BMS:

Are you interested in learning more about high-output prismatic battery pack assembly? Contact us today to secure an expert consultation!

Method 1: This method involves connecting the parallel BMS module&#;s P-wire to the BMS first. The common port should be connected to the BMS P-wire and the separate port should be connected to the BMS C-wire. Then connect B- and B+ in turn. After connecting the wires, plug in the BMS and parallel BMS module ports first, then the B+ port, and finally plug in the control signal wire to the protection board.

Method 2: This method involves plugging in the BMS and parallel BMS module ports first, then plugging in the B+ port, and finally plugging in the control signal wire to the BMS.

It is important to follow these methods strictly and operate in sequence. Reversing the wiring sequence can cause damage to the parallel BMS module.

The BMS and parallel BMS modules must be used together and cannot be mixed. Wiring should be done according to the purchased parallel BMS module corresponding to the current.

Edit by editor

For more information, please visit high-output lifepo4 battery pack assembly.